![]() ![]() Holding the Beugler tool like a pen may limit control and versatility. Lifting at the end of this stroke produces a pointed tip. If you tilt the tool from flat position to its edge you.will achieve a tapered line either straight or curved. Only when the wheel rotates on a surface will paint be distributed. Even shaking the tool will not produce a drip. The speed that you pull the tool or changes in the speed have no effect on the stripe size. With a twist of the wrist a curving, even line can easily be applied. Place the wheel down firmly and pull, rolling the stripe on your surface. Before striping,prime the tool with a couple of short strokes, which coats the wheel with wet paint. The Beugler tool should only be used with the wheel rotating in this direction. You’ll find the Beugler tool will stripe everything with ease. Using enough downward pressure for the wheel to roll, begin striping. Wipe off any excess paint before striping. Remember, the wheel rotates to pick up paint in its serrations. Hold the tool vertically and gently expel the air in the barrel and lift the paint to the wheel by pressing the plunger upward until you see a small bead of paint at the wheel. Be sure to align the wheel head with the guide bar on top. Once you have filled the tool with the appropriate amount of paint, replace the wheel head by pressing it firmly onto the paint barrel. Most paint can be used directly from the can if it has a creamy consistency. Pull the plunger back allowing space for your paint. To load the Beugler striping tool remove the wheel head by firmly pulling it off. THE TOOL’S PLUNGER PROVIDES A READY SUPPLY OF PAINT WITHOUT PRESSURIZING THE BARREL. When rotated the wheel picks up and distributes paint evenly by way of precision serrations, regardless of speed of application. ![]() The Beugler striping tool consists of a paint barrel and a friction fit wheel head. The Beugler Striper’s precision design and machining allows for an even layer of paint to be applied without variance in thickness or width.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |